Chassis Brackets Cabtron Chassis brackets are capable of supporting heavy loads and relieving stress to front panel mounted equipment. Consisting of two parts, the lower angle is fabricated of 16 gauge cold rolled steel. All parts are zinc plated with yellow chromate in accordance with ASTM-B633-78SC2 Type II. The lower angle is adjustable vertically along the cabinet panel mounting angles and the top angle is adjustable to the chassis width. All mounting hardware supplied. When full cabinet depth chassis brackets are not required shorter chassis brackets may be used by ordering an additional pair of panel mounting angles. CAUTION: If cabinet has either air ducts, receptacle strips or ground strips - full depth chassis brackets may not be used. We suggest either shorter chassis brackets or using the adjustable chassis brackets (CBA) shown below. Back   CMP Enclosures 3901 Grove Avenue, Gurnee, Illinois 60031 Phone 847.244.3230 Toll Free 1.888.CMP.ENCL (1.888.267.3625) Fax 847.244.3257 E-mail: info@enclosures.com